NEWS CENTER


WXHUAXIA

What are the operating requirements of the steel bar straightening and cutting machine?


Release time:

2023-02-10

The steel bar straightening and cutting machine is a machine used for steel bar processing. With the development of economy and technology,Steel bar straightening and cutting machineThe use of the began to develop in the direction of humanization. The new steel bar straightening and cutting machine has many advantages and characteristics of use. So for users, what should be paid attention to in the operation of the steel bar straightening and cutting machine?

The operation requirements of 1. rebar straightening and cutting machine are as follows:

1. First of all, before using the machine, it is necessary to check the equipment, including whether the circuit of the equipment is normal and whether the processing part of the machine has been properly adjusted. Because of different processing specifications, the steel bar straightening and cutting machine needs to be controlled within a reasonable range. At the same time, before launching,Steel bar straightening and cutting machineThe placement is also a problem that users need to pay attention to, try to choose a more spacious processing environment and a more flexible use angle. At the same time, the position of the machine should be as horizontal as possible to ensure the accuracy of the machine processing steel bars.

2. Secondly, do not rush to use the machine after starting the machine, but fully understand the overall condition of the machine. The usual method is to adjust the machine to idle mode. Usually, wait for a while before using the machine. The purpose of idling is to preheat the various parts of the machine. At the same time, if the machine fails during repeated use, timely idling and inspection can improve the safety performance of the machine.

When using the machine, when the machine does not reach the normal speed, do not cut the steel bars. This is not only a kind of damage to the machine, but also leaves some unnecessary marks on the steel bars, which is not worth the gain. At the same time, when cutting steel bars, master the correct cutting direction. In particular, avoid the hard part of the steel bar, and do not fix the material by hand when cutting the steel bar, so as not to affect the safety of the processing.

3. The use of the steel bar straightening and cutting machine needs to be carried out in the correct order of use of the machine, and the equipment should be adjusted reasonably before processing. There are many matters needing attention in the operation of the steel bar straightening and cutting machine. From the user's point of view, a reasonable understanding of the steel bar straightening and cutting machine will help the use of the machine.Steel bar straightening and cutting machineThe manufacturing performance and the technology in place meet the usual use in various fields, and can be said to be one of the indispensable machines in many industries.

2. maintenance: maintenance per shift (before, during and after each shift)

1. Clean the engine body according to the lubrication table and add the specified oil.

2. Check each bolt to make sure it is not damaged and tightened. The tightness of the V-belt shall be 10~15mm in the middle of the belt, and all protective devices shall be complete and intact.

3. Check the circuit and switch. The threaded connection is firm, the fuse meets the requirements, the switch contact is reliable, and the grounding is good.

4. Adjust the gap between the fixed blade and the movable blade. Under normal circumstances, the overlap between the two blades is 2mm, and the gap should not exceed 0.3mm

5. The bolts of the blade holder must not be loose. If the blade becomes dull, the blade should be replaced.

6. Check the clutch. The contact shall be stable and the separation shall be complete.

7. Turn 2~3 circles by hand for test run. After all parts are flexible and smooth, turn on the power and run for 1~2 minutes. All parts shall work normally without abnormal noise.

8. Check bearing temperature during operation. The temperature of rolling bearings and sliding bearings shall not be higher than 600 ℃, and the temperature rise of the motor shall not exceed 600 ℃.