NEWS CENTER


WXHUAXIA

One minute to understand the functions and characteristics of the steel straightening machine


Release time:

2023-01-20

The structure of the steel bar straightening machine is to adjust the angle of the straight wire mold by rotating the rotor at high speed, so as to achieve the effect of straightening. Then we use the threading wheel to pull the line forward. After the wire reaches the required size, touch the positioning key and push the walkway forward by 5mm. The vertical wire cutting machine is pressed down by the upper punching machine, the wire is cut off immediately, the wire is pressed by the pressing plate on the vertical wire cutting pliers to press the bearing open, and the wire automatically falls into the wire rack. To change, move the navigation key.

The steel bar straightening machine has the characteristics of reasonable structure, simple operation, convenient operation and reliable work. It is suitable for straightening chicken cages, rabbit cages, building nets, various control welding wires, dredging plate plug-in cutting and special-shaped mesh wires..

What are the functions and characteristics of the steel bar straightening machine? Here's a look.

1. There is no error in the cutting length of the steel bar. 2. Double head pull type. 3. Until the steel bar is adjusted and pulled out. 4. Tungsten steel die is adopted for the construction wire. 5, the product wire adopts the ball die, the steel bar will generally not cause damage to the surface.

The working principle of the steel bar straightening machine: First, the motor is driven by the belt to increase the speed, so that the straightening cylinder rotates at a high speed, the steel bar passing through the straightening cylinder is straightened, and the rust on the surface of the steel bar is removed by the straightening die.

The motor drives and decelerators through another pair of speed reduction belts. On the one hand, it drives the two transfer rollers and the pull rod to move forward; on the other hand, it drives the crank wheel to move the hammer up and down.

When the steel rod is adjusted to the predetermined level, the hammer head hammers on the tool holder to cut the steel rod. When the cut steel rod falls into the receiving frame, the tool holder returns to its original position under the action of the spring, completing a cycle.

What are the matters needing attention in the installation of steel bar straightening machine?

1, the location needs to have a solid drainage system and reliable equipment foundation.

2, steel bar straightening machine processing enterprise site should be set up around the warning area and warning signs, and set up construction management protection fence.

3, tower crane swing radius inside and outside should be set up fence and anti-smashing shed. Electricity consumption should be standardized, with zero, grounding and leakage protection devices.

4, the staff should undergo skills training, qualified rear can work.

What are the operating procedures of the steel bar straightening machine?

1. Special personnel shall be responsible for the equipment.

2, operation personnel shall not be too far away from the machine, feeding, threading, cutting head need to stop.

3. During the straightening process of the steel bar, when the steel bar jumps out of the tray guide groove, the top does not reach the fixed length mechanism, or the steel bar is broken, the limit switch should be pressed in time to stop cutting the steel bar, and it can only be used after adjustment.

4, steel plate adjust to the bottom or straighten short steel, steel should be pulled to the straightening cylinder, hold the sleeve by hand, so as not to shake freely hurt people.

5. Before the straightening block is not fixed and the protective cover is not covered, do not penetrate the steel bar to prevent the straightening block from flying out and hurting people after starting up.