NEWS CENTER


WXHUAXIA

Rebar straightening machine requires strict operating procedures


Release time:

2023-01-03

  Rebar straightening machineIt is mainly aimed at steel bars, that is to say, industries that do steel bar processing generally have to haveRebar straightening machineThe participation can be normal operation. So what is the structure of the steel bar straightening machine? Mainly by the high-speed rotor rotation to adjust the angle of the straight wire die, from to achieve the effect of straightening, and then through the wire wheel to the front of the wire. This kind of straight wire machine has the characteristics of reasonable structure, more convenient operation, safer and more reliable use, etc., so it is suitable for chicken cages, duck cages, dog cages, squirrel cages, rabbit cages, various welding wires, building meshes, and special-shaped meshes. Straightening of wire and shule plate insertion wire truncation. Is it widely used, thenRebar straightening machineWhat are the main features?

1. It can be straightened by double-head pulling type;

2. There is no error in the length of the cut steel bar;

3, one meter of steel bar is pulled out after adjustment;

4. The material used in the general construction wire is tungsten steel mold;

5. What is the product wire used? It is the ball end mold, and the steel bar transferred from it will not hurt the surface.

This is the use of some of the characteristics of the steel straightening machine and the main function. The steel bar straightening machine requires strict operating procedures to ensure that there are no problems during use and to ensure safety.

(1) The receiving and feeding worktable should be level with the lower part of the tool, and the length of the worktable can be determined according to the length of the processed material. When processing long steel bars, special personnel shall be assigned to assist, and the operator shall obey the command and shall not push and pull at will.

(2) Before starting up, it is necessary to check that the cutter is free of cracks, the tool holder bolts are fastened, and the protective cover is firm. Then turn the pulley by hand, check the gear meshing gap, and adjust the cutter gap.

(3) After starting, it should be idling first, and check whether the transmission parts and bearings are working normally before operation.

(4) Do not cut materials when the normal speed is not reached. When cutting, you need to use the middle and lower part of the cutter to hold the steel bar and align it with the knife edge to quickly feed it. The operator should stand on the side of the fixed blade and press the steel bar firmly to prevent the end of the steel bar from popping up and hurting people. It is strictly forbidden to hold the steel bars on both sides of the blade with both hands and bend over to feed.

(5) The diameter and strength of the mechanical nameplate shall not be cut to exceed the provisions of the steel bar and red-hot steel bar. When cutting multiple steel bars at one time, the total cross-sectional area shall be within the specified range.

(6) When cutting low-alloy steel, high-hardness tools should be replaced, and the cutting diameter should meet the requirements of the mechanical nameplate.

(7) Cut short material, the distance between the shearing machine and the blade should be kept above 150mm. When the clamping end is less than 400mm, the short end of the steel bar shall be pressed or clamped with a sleeve or clamp.

(8) During the operation, it is strictly forbidden to remove the broken ends and sundries nearby by hand directly. Non-operators are not allowed to stay around the steel bar swing and near the knife edge.

(9) When it is found that the mechanical operation of the bar shearing machine is abnormal, there is abnormal noise or the cutter is skewed, it should be stopped immediately for maintenance. The maintenance needs to be stopped and the power cut off to continue.